Quality inspection

In addition to quality verification of new products during development and design, and the first and patrolling inspections of the products during the production phase, the final full inspection is also an important part of strengthening quality. The bakelite skeleton is a fragile product that can cause damage abnormalities at every stage of production, such as collision during burr processing, collision during pin insertion, and collision during product rotation. Therefore, it is necessary to carry out all the inspections in order to screen out defective products and ensure that the products delivered to the customers are good products and enhance the company's quality image. In the final inspection, it is best to arrange experienced old staff to operate, for each product, after the full inspection guide is hanged in the full inspection phenomenon, the whole inspector selects according to the instructions. Try to make sure that every part of each product can be confirmed at a slower pace.

The above product design, mold design and manufacturing, and production stages are related to each other, and each process will affect the entire skeleton production. Product design directly affects the design and manufacture of the mold, and it is impossible to design and manufacture the mold according to the product structure. When the product structure design is unreasonable, the mold will have indirect effects during injection molding, such as the colloid is too thick and shrinks. The problem is that the structure is thin and fragile, and the design is unreasonable; when the pin is pinned, the colloid at the edge of the pinhole is thin, resulting in poor cracking. Therefore, in the design and manufacturing process of the entire skeleton, design is a very important part. A good design will bring a lot of unnecessary mold-modifying actions for subsequent production, and the product rejection caused by high quality defects.